Oil on block paving looks permanent, and many people assume that the blocks have to be replaced. In most cases they do not. Here is how to remove oil from a block paving driveway, and why the age of the stain matters so much.
Oil stain on your block paving?
Send us a photo of the stain and tell us roughly how old it is, for a free quote.
The short answer: yes, oil can be removed from block paving. A fresh stain comes out far more easily than an old one. The older the oil is, the harder the job becomes, but it is not impossible. We remove oil stains with hot water and steam, and we can then seal the paving so that the next spill stays on the surface.
Why oil is so stubborn on block paving
Block paving is porous. Oil does not sit on top of the blocks: it soaks into them, and into the sand in the joints. Every week that it stays there, it sinks a little deeper and sets a little harder. That is why two stains that look the same can behave very differently when they are cleaned.
Fresh oil or old oil: what to expect
- A fresh stain is still near the surface, so it lifts much more easily.
- An old stain has had months or years to soak in. It takes more work and more treatments, but it can still be removed.
If your car has just leaked, the best thing you can do is soak up the oil with cat litter or sand, and avoid hosing it. Our guide on how to remove oil stains from a driveway explains the first steps.
How we remove oil from block paving
Cold water does very little to oil. Heat is what moves it. We work with bespoke, professional oil removal agents and a degreaser, a professional pressure washer and a hot water boiler, and with steam where the stain needs it, so the oil is lifted out of the block instead of being spread across the driveway.
Oil removal is usually done as part of a full clean. After every block paving clean, we put the kiln-dried sand back into the joints, because no block paving should be left without it. You can see the whole process on our block paving cleaning in Bristol page.
How to stop oil soaking in again
Once the paving is clean, a sealer is the best protection against the next leak. On sealed block paving, oil stays on the surface instead of soaking into the blocks, so it is much easier to clean off. The same is true of an accidental paint spill. Read more about the benefits of a block paving sealer, or see our block paving sealing service.
Our aim is not to have the lowest prices, but to deliver the best quality service for the price that you pay.
Oil on block paving: FAQs
Can oil stains be removed from block paving?
Yes. Fresh stains come out much more easily than old ones, but even old oil can be removed with hot water, steam and the right treatment.
Do I need to replace oil-stained blocks?
In most cases, no. Oil removal is usually enough, and replacing blocks is a last resort.
Why is old oil harder to remove from block paving?
Block paving is porous, so the oil keeps sinking deeper into the blocks and hardens over time.
How do I protect block paving from oil?
Have it sealed. On sealed paving, oil stays on the surface, where it is much easier to clean off.
Block paving cleaning in Bristol
Cleaned, treated and always re-sanded with kiln-dried sand.